![]() Same again for the Engine Master Switches, they're on, flick them down, nothing. Go to Settings->Controls and delete all joystick assignments for all throttle assignments (even if you have. FSUIPC itself uses two completely separate sets of offsets, ones for Applications to write to, the other to read back from. But I've then tried to setup my controls in the FSLabs Input commands and they don't seem to work? Such as I try to move the engine starter to CRANK or IGN/START and on the aircraft it doesn't move? Is it set so that when we do it on the Hardware it doesn't do it on the aircraft? Although that would be weird if so. Now, I've managed to set up my Throttle 1 & 2 in FSUIPC and then set up the Detent Settings properly in the FSL (Check photo). Step 3: In the Sim-Avionics FSUIPCIO. Just after the release of Microsoft Flight Simulator weve received a lot of questions about setting up a flightstick. I've not used a throttle with a Reverse Thrust setting in it before so setting up was quite easy before. Most current interface solutions are able to read/write with FSUIPC, so a typical setup to map a battery switch might be: Step 1: Press a button in your sim Step 2: This is detected by your I/O card and its software writes a 1 to a specified offset. Hey! I'm trying to make my Thrustmaster TCA Throttle my main throttle and I'm struggling to set this thing up. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |